Circle cotter pins are wound or turned on from the middle
out. Start by threading the open wire end inside the circle
cotter into the hole on shaft or pin. Turn the ring until
it snaps into place. To remove the circle cotter, turn again
in the same direction.
A very
secure fastener, circle cotters are used where sharp ends
are not allowed. Smooth all around, this fastener is ideal
for applications associated with fabric. Made
from hard drawn MB spring wire, zinc plated or stainless type
302
Circle cotter pins are wound or turned on from the middle
out. Start by threading the open wire end inside the circle
cotter into the hole on shaft or pin. Turn the ring until
it snaps into place. To remove the circle cotter, turn again
in the same direction.
