Rue Ring
cotter pins surround the shaft. The automatic lock makes this
one of the safest cotters available today. Best used in light
to medium applications. Rue Ring cotters install fast without
tools.
Additional
feature is the manual secondary lock which tensions the Rue
Ring tight and dampens vibration.
Made of
hard drawn MB spring wire, zinc plated or stainless type 302..
Hole
Placement end shaft only
Rue Ring
Cotters will retro fit most standard applications without
design changes.
Total width of any Rue Ring equals
3 of its wire diameters. The straight wire shaft which goes
through the pin hole is one, plus two additional wire loops,
one on each side, front and back.
Recommended
hole size is 2 times the wire diameter of the selected
Rue Ring. This leaves the Rue Ring short of interfering with
effective shaft length.
Recommended
web thickness is a minimum of 1 wire diameter and a maximum
of 2 wire diameters. A thicker web results in more holding
power but makes installation and removal more difficult.
Additional
feature is the manual secondary lock which tensions the Rue
Ring tight and dampens vibration.
Total width of any Rue Ring equals
3 of its wire diameters. The straight wire shaft which goes
through the pin hole is one, plus two additional wire loops,
one on each side, front and back.
